How To Build A Swing Down Bicycle Storage Lift (Free Plans!)

55 Просмотры
Издатель
In this video I will show you how to build a bicycle storage lift that swings down from the ceiling so that you can gain back that precious floor space in your garage! This type of bicycle storage is fantastic because you will not need a ladder to access your bicycles. The entire frame swings down from the ceiling to allow for easy access to your bikes.

Even when hanging in the vertical position, it allows you to stack two bikes vertically and get them off the ground. What a great way to utilize your space!

Follow along to see how I built mine and see below for the materials I used to make this project.

Materials used for this build were as follows:
► 2x2 Lumber
► 2x4 Lumber
► 3/4" Plywood
► 3/8" Threaded Rod, washers, nuts
► 3/8" Eye Bolts
► 1/4" Chain
► Timberlock structural screws
► Worm Gear Winch with steel cable
► Pulley Blocks

You can access the PDF drawings for this build here:

► https://www.thingiverse.com/thing:4616823

Be sure that you are using a worm gear winch, or at the very least a winch with an automatic brake to control the descent of the load. This could fall on your head if the winch is left to free wheel! Be careful and be sure your load is securely attached to your joists with anchors or structural screws. Do not just use wood screws to support heavy loads!

As always, if you have any questions or comments, please leave them below! I try to answer every single question!

Thanks for watching!

#DIY #EBIKE #BICYCLE

****************************************************************

If you enjoy and have benefited from my content and are feeling generous I would love your support! You can "buy me a coffee" here:

► https://www.buymeacoffee.com/embraceracing ☕

By supporting my channel you are encouraging me to continue with this time consuming endeavor. A lot of time goes into design work, building my projects, filming the videos, editing the videos, etc. Plus it all costs money! Your generosity goes a long way in helping me bring you better content as often as I can!

Follow me on Instagram!

► https://www.instagram.com/embraceracing/
Категория
3d принтер своими руками
Комментариев нет.