Fixing the 3D Printer Thermistor Cable!

44 Просмотры

  • Спасибо! Поделитесь с друзьями!

    Вам не понравилось видео. Спасибо за то что поделились своим мнением!

admin
Издатель
When I tried to print the flower pot in the previous video, my 3D printer would stop randomly around 5 minutes in or sometimes right at the end. The issue turned out to be the bed's thermistor cable that reports the temperature to the main board. I saw drops in the temperature graphs. Octoprint would throw a MINTEMP error after too many drops. When I took apart the cables, the thermistor cable's connector fell apart in my hands. So after I replaced the cables with a new set, it all started working again! To celebrate, I printed out a banana cage for my bike, but it didn't fit on my unusual bike. Oh well!

Replacing The Lulzbot Mini 1.03 Bed Cables Workflow
https://ohai.lulzbot.com/project/lulzbot-mini-103-bed-cables-replacement/maintenance-repairs/

Banana holder for bike
https://www.thingiverse.com/thing:2777346
Категория
3D Принтеры
Комментариев нет.

Следующее