Издатель
Ayse Tekes, assistant professor of mechanical engineering in the Southern Polytechnic College of Engineering and Engineering Technology, and Tris Utschig, director for scholarly teaching in the Center for Excellence in Teaching and Learning, have worked together for the past two years.
Their research focuses on how to improve student learning in mechanical engineering by using low-cost, 3D-printed laboratory devices in active learning experiences.
Their research focuses on how to improve student learning in mechanical engineering by using low-cost, 3D-printed laboratory devices in active learning experiences.
- Категория
- 3d принтер своими руками
Комментариев нет.
Следующее
-
44:33
Digital Matters Fall 2020 Workshop (Justin Sorensen, GIS Specialist)
-
43:36
Week 1 - Fall 2020 DCIM Capstone Class
-
10:31
IS 2020 Fall Lecture 21
-
16:25
Which 3D Printer to buy in fall 2020
-
14:20
Changes to Fusion 360 free Personal Use License Explained (Fall 2020)
-
39:38
Fall Workshops 2020 - 3D Printed Design
-
1:19:01
Research Talks – Fall 2020 Graduate Fellows and Faculty Grantees Projects
-
36:44
UX/UI Research & Design Use Case Study | Fixie 3D & Nimbus Research Centre
-
1:06:55
Introduction to 3D Modeling and Scanning, Fall 2020 Digital Scholarship Workshop
-
03:30
3D Printing at Pendergrass Library - Fall 2020
-
07:34
Неразборные подвижные механизмы - моделирование и 3D-печать | Autodesk Fusion 360
-
11:11
3D печать воском / как печатать филаментом WAX
-
20:40
Печатаем то, что не купить! Мой новый 3D принтер TEVO Tornado!
-
14:25
-
22:07
3D печать в Швейцарии / Prozhektor8kvt в Швейцарии
-
10:02
3D-печать Nylon и Flex. Советы и рекомендации. 3d печать Nylon на открытом 3D-принтере
-
42:56
Всё про 3D печать – Михаил Пономарев
-
08:49
Прозрачный ABS Bestfilament Сопло 03 на Prusa i3 3D ПРИНТЕР
-
20:01
3d печать ШЕСТЕРНИ. ТЕОРИЯ И ПРАКТИКА. Модульная и питчевая системы
-
13:14
3д-печать: Диаметр сопла - 0.2мм 0.4мм 0.8мм
