3D Print Timelapse - Flipper Zero Case #3dprinting #timelapse #fail

8 Просмотры

Спасибо! Поделитесь с друзьями!

Вам не понравилось видео. Спасибо за то что поделились своим мнением!

Издатель Dec 9, 2023

This print was designed by DevWolf and can be downloaded at:
https://www.printables.com/model/562327-flipper-zero-case

A remix by DevWolf from Shutdown and RobbS. A great little Pelican style case with the ability to place a TPU gasket to seal up the lid. This wonderful remix allows for an SD card, the Flipper Zero with case and the Wi-Fi card. However, I made quite a few mistakes in this print.

-First, when your belt tension is too tight you burn through belts. Both my X and Y belts have been squeaking for about a week now and are starting to shred. This is causing layer shifts during the print process for both axes. I have new belts but haven't had the time.

-Second, I attempted to paint the Flipper logo on the top opposed to printing a base layer in another color and using z-hop. I didn't expect the paint to bleed as much as it did. So, I sanded the top to remove much of the unwanted paint.

-Third, my screw supply was low wo I used nails for the hinge pins. It works but looks bad.

-And lastly, when printing a light-colored filament, I need to turn down the light, the subject is WAY over exposed.

Learn from my mistakes.

Leave a comment below if you are interested in this print or have any suggestions. I would love to hear from you.

My designs can be found below.
Thingiverse:
https://www.thingiverse.com/benovation3dprints/designs

Thangs:
https://thangs.com/designer/BenOvation

Printables:
https://www.printables.com/@BenOvation3D_1228145

I am not sponsored by any of the creators or sites mentioned. All items printed from the wonderful creators on Thangs, Thingiverse or Printables deserve all due credit. Please use the above link to the design to give credit to those who work so hard to give us fun and useful prints. Please check my about page for more information. Be sure to look at the Creative Commons license 4.0 link below.
https://creativecommons.org/licenses/by/4.0/

So far, I have exclusively used Overture products with amazing results. You can get this great filament here! (I am not sponsored, just a fan.)
PLA - https://amzn.to/47tV0tS
PETG - https://amzn.to/3ukgM4K
ASA - https://amzn.to/47zFahd
TPU - https://amzn.to/3R2siuo

Anycubic Kobra Plus - https://amzn.to/3R2QRGH

If you like this design and want to buy me a cup of coffee for my work, I am very appreciative, I will display your username on my next video as a thank you.
https://www.buymeacoffee.com/Benovation3dprints