Step by Step Installation Guide for Fusion 3 F410/F400 3D Printer Metal Upgrade Kits

31 Просмотры
Издатель
This is an in depth step by step installation guide for the Fusion 3 F410/F400 3D printer metal upgrade kits. The video is very long, so feel free to use the chapters to skip around.

Here is a link for the .9 degree steppers
https://a.co/d/iVdqvdK

If you have any questions or would like to order any mods, here is my email address. Feel free to send me a message, and I will reply back asap.

Samsondoggy@yahoo.com

00:00 Introduction
03:12 Disassembly
13:16 Marking the Rails
16:12 Installing the Y Axis Carriages
23:18 Installing the X Axis Gantry Rail
27:29 Installing the Cross Brace
31:02 Installing and Positioning the Cable Tensioners
42:03 Installing the X Axis Carriage
43:31 Installing the Stepper Brackets
48:05 Installing the Y Axis Limit Switch
52:13 Removing the Cable Spools and Stepper Dampers
01:01:59 Wrapping the Spools
01:13:24 Installing the Wrapped Spools to the Stepper Motors
01:18:17 Installing the stepper Motors
01:26:42 Shimming the Carriages
01:28:55 Marking the Cables
01:37:16 Attaching the Cables to the Cable Anchors
01:52:33 Setting and Checking the Cables
02:02:20 Installing the X Axis Limit Switch
02:04:05 Installing the Drag Chain
02:09:49 Installing IR Board (F-400 Only)
02:13:38 Installing the Hotend
02:16:20 Installing the Bed Tabs
02:21:10 Soldering the .9 Degree Stepper Motors (If applicable)
02:23:31 Setting the Steps/mm in Duet for .9 Degree Steppers (If applicable)
02:25:48 Final Conclusions
Категория
3d принтер своими руками
Комментариев нет.