SLA PRINTING - Anycubic Photon Mono SE System - Unbox - Print - Practical Review

33 Просмотры
Издатель
After years owning a Dremel 3d20 FDM Printer, I bought the Anycubic Photon Mono SE and the full Wash And Cure 2.0 System to check out SLA printing. Here's a full unbox, print and practical review.

Table of Contents for the Lazy:
00:16 - Part 0: Welcome Back
00:45 - Part 1: Mono SE Unbox, Impressions
10:24 - Part 2: Wash and Cure 2.0 Unbox, Impressions
20:37 - Part 3: Printing for the first time
27:41 - Part 4: Washin' and Curin'
31:55 - Part 5: Wrap up and Final Thoughts

Since I spent my own money, I also compare this to the Photon Mono which is in the same price range and discuss whether you should by the SE or the Mono. Enjoy!

Video ERRORS: The Audio gets a bit wonky at a couple of the transitions, my noise reduction filter must have gotten deleted... Sorry about that!


Edited in TechSmith Camtasia Studio 2021
Категория
Фотополимерный 3d принтер
Комментариев нет.