This is a simple way to easily load and unload filament from the Orbiter extruder. This method does not require to open the latch every time you change the filament.
G Code example:
G0 E-5 F3600 ;extract filament to cold end area
G4 S3 ;wait for three seconds
G0 E5 F3600 ;push back the filament to smash any stringing
G0 E-15 F3600 ;Extract back fast in the cold zone
G0 E-60 F300 ;Continue extraction slowly, allow the filament time to cool solid before it reaches the gears
You may need to adjust timing and extraction lengths depending on your hotend. These setting works well with my Dragon HF hotend.
Join our facebook group:
https://www.facebook.com/groups/705637896767655
Discord Channel:
https://discord.gg/9sxgt2fvE9
Orbiter versions you can find here:
https://www.thingiverse.com/thing:4223085
https://www.thingiverse.com/thing:4725897
The printer I used in this test:
https://www.thingiverse.com/thing:4312043
G Code example:
G0 E-5 F3600 ;extract filament to cold end area
G4 S3 ;wait for three seconds
G0 E5 F3600 ;push back the filament to smash any stringing
G0 E-15 F3600 ;Extract back fast in the cold zone
G0 E-60 F300 ;Continue extraction slowly, allow the filament time to cool solid before it reaches the gears
You may need to adjust timing and extraction lengths depending on your hotend. These setting works well with my Dragon HF hotend.
Join our facebook group:
https://www.facebook.com/groups/705637896767655
Discord Channel:
https://discord.gg/9sxgt2fvE9
Orbiter versions you can find here:
https://www.thingiverse.com/thing:4223085
https://www.thingiverse.com/thing:4725897
The printer I used in this test:
https://www.thingiverse.com/thing:4312043
- Категория
- Thingiverse
Комментариев нет.