Fixing 3D printer Anet8 - display brightness

25 Просмотры
Издатель
How to easy fix brightness on Anet 8, 3D printer. This printer have type of display 2004, that's meant 20 characters in 4 rows. Brightness and Contrast can not user setup inside software or by pot by hardware(any pot is not included). For display brightness fix you only need 4k7 (4.7 kilo ohm)resistor and soldering gun.


A guide:

1. Turn off 3D printer

2. On backside of the display PCB solder pin 2 to resistor leg one and pin 3 to resistor leg two. Please see video.
3. Turn on 3D printer and see the result.
Категория
3D Принтеры
Комментариев нет.