In this tutorial, I'm following up from Part 1, the designing of the pendant, to this part, part 2 where we will be 3d printing the four pendants with my sonic mini monochrome 3d printer. I will also be covering some of the things you will need to know about casting this out, so that you can follow the correct burn out schedule on your casting furnace, as this is very important.
Part 1 - Designing the Pendant: https://youtu.be/K9xQJ4pD2XA
Part 1 Blog: https://myjewelrybench.com/5-stone-diamond-pendant-part-1-designing
If you like these videos, please subscribe and give a Thumbs UP!
Every Little Bit Helps!
For more jewelry and watch related repair info, visit my website at
https://www.myjewelrybench.com
If you would like to help keep this channel funded, consider
a donation at
www.patreon.com/myjewelrybench
Part 1 - Designing the Pendant: https://youtu.be/K9xQJ4pD2XA
Part 1 Blog: https://myjewelrybench.com/5-stone-diamond-pendant-part-1-designing
If you like these videos, please subscribe and give a Thumbs UP!
Every Little Bit Helps!
For more jewelry and watch related repair info, visit my website at
https://www.myjewelrybench.com
If you would like to help keep this channel funded, consider
a donation at
www.patreon.com/myjewelrybench
- Категория
- 3d принтер своими руками
Комментариев нет.