first attempt at doing a 3d printed time lapse on my new setup hope you
enjoy
print time was 4 hours with 6% infill with 3 layers running on the
Creality CR10
big thank you to Vedran Marjanović for sharing this file check him out in link below
https://www.myminifactory.com/object/3d-print-joker-bust-81639?fbclid=IwAR1APQKyDn7EyKfDhITOCyF8byfnzTdmKQKoJbS5HsLKNM5ycgtDM-ex7nk
I Am a Man Who Will Fight for Your Honor by Chris Zabriskie is licensed under a Creative Commons Attribution 4.0 licence. https://creativecommons.org/licenses/by/4.0/
Source: http://chriszabriskie.com/honor/
Artist: http://chriszabriskie.com/
enjoy
print time was 4 hours with 6% infill with 3 layers running on the
Creality CR10
big thank you to Vedran Marjanović for sharing this file check him out in link below
https://www.myminifactory.com/object/3d-print-joker-bust-81639?fbclid=IwAR1APQKyDn7EyKfDhITOCyF8byfnzTdmKQKoJbS5HsLKNM5ycgtDM-ex7nk
I Am a Man Who Will Fight for Your Honor by Chris Zabriskie is licensed under a Creative Commons Attribution 4.0 licence. https://creativecommons.org/licenses/by/4.0/
Source: http://chriszabriskie.com/honor/
Artist: http://chriszabriskie.com/
- Категория
- 3Д Печать
Комментариев нет.